7020 toe?
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=68684
Printed Date: 06 Sep 2025 at 2:49pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 7020 toe?
Posted By: Mrgoodwrench
Subject: 7020 toe?
Date Posted: 14 Apr 2013 at 12:00pm
the front end or our 7020 was set in the whole way and had a bad tie rod end. we got that fixed yesterday and set the width. how much toe in or out should we be running? they seem to be toed out a little at this point
-------------
There are 3 ways to do job GOOD, FAST, CHEAP. YOU MAY CHOOSE 2. If its FAST & CHEAP it won't be GOOD, if it's GOOD & CHEAP it won't be FAST, and if its GOOD & FAST it won't be CHEAP!!!!
|
Replies:
Posted By: DougG
Date Posted: 14 Apr 2013 at 12:13pm
|
Just measure the inbetween on the front of the tires and then the back of them and put them the same, should get ya there
|
Posted By: Mrgoodwrench
Date Posted: 14 Apr 2013 at 1:47pm
so 0 toe?
-------------
There are 3 ways to do job GOOD, FAST, CHEAP. YOU MAY CHOOSE 2. If its FAST & CHEAP it won't be GOOD, if it's GOOD & CHEAP it won't be FAST, and if its GOOD & FAST it won't be CHEAP!!!!
|
Posted By: tornado8070
Date Posted: 14 Apr 2013 at 2:35pm
I believe the manual stats up to a half inch toe is acceptable. I don't have it in front of me but I just narrowed up the 8010 a few weeks ago and I'm pretty sure that what it said.
-------------
09’ DT205B, 08’ DT220A, 83' 8070 MFWD, 83’ 8070 85’ 8050 MFWD, 83' 8030, 82' 8010, 85’ 6080 MFWD, 84’ 6080, 79' 7020, 85' M3 RWD, 85' 920 diesel,AC C-50 forklift.
|
|