Print Page | Close Window

Wiring Harness Installation - wd-45

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=57951
Printed Date: 06 Sep 2025 at 3:24am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: Wiring Harness Installation - wd-45
Posted By: Brampton 02 gt
Subject: Wiring Harness Installation - wd-45
Date Posted: 07 Oct 2012 at 9:03am

Does anyone have a reference or could provide a few pictures showing the routing of the harness on the tractor.  I am tracking down the harness clips and need to figure out the routing of the wiring.

thanks!
Curtis


Replies:
Posted By: Allis dave
Date Posted: 09 Oct 2012 at 7:44am
I don't have any pictures, but I'll try to explain. For this post Left means left of the tractor when sitting on the seat.
THe whole harnass comes out of the instrument panal, preferebly with a rubber grommet around the slot the harness comes out of. From there it runs around the left side of the barrery box and on the left edge of the trans clutch cover. I have a wire clip held by one of the cover bolts, but I'm not sure if this is original. I have another clip on the left side of the clutch housing instection cover bolted to a cover bolt. After that the ignition wire runs under the starter over to the right side. I had to remove the start to get the wire under the starter. About where the clutch hoursing bolts to the frame rail the generator wires run into the inside of the frame rail and to the generator.
 
Hope this helps. If you still need pictures I can get some but it may be a couple days.


Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net