Farm Equipment - CA carb question

Print Page | Close Window

CA carb question

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=57526
Printed Date: 15 May 2025 at 4:38am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: CA carb question

Posted By: bshook78
Subject: CA carb question
Date Posted: 27 Sep 2012 at 4:06pm

I am trying to locate a part number for the carb on my CA. Where do I look? I am needing to get a kit for it, but I'm not sure what I need. Any help would be appreciated.

Replies:

Posted By: SteveC(NS)
Date Posted: 27 Sep 2012 at 6:07pm

My parts catalogue mentions Zenith model 161j7 or Marvel-Schebler assy. # TSX-486.

any of our great advertisers-supporters-members here would be able to tell you much more than I.

Posted By: bshook78
Date Posted: 27 Sep 2012 at 7:39pm

Thanks Steve. I will try to post a pic tomorrow and see if anybody can possibly identify it. I am not sure where the part no. should be located. I looked earlier, but I am guessing I will need to take it off to find it. I haven't gotten that far yet.

Posted By: Chalmersbob
Date Posted: 27 Sep 2012 at 9:31pm

The carb should have the mfg name on the side of it. The model # is usually on a brass tag on the top of the carb. Once you know the mfg of the carb, a kit is not had to find unless the carb is not original to the tractor. LOL Bob

-------------
4 B's, 1 C's,3 CA's, 2 G's WD, D14, D15, B-1, B10, B12, 712S,

Posted By: Steve in NJ
Date Posted: 27 Sep 2012 at 11:04pm

CA's had either a small bore Zenith or a small bore Marvel Schebler on them. The Zenith has a disc rivited to the top of the float bowl about the size of a dime. Outside number on the disc is the AC number. The number stamped in the disc closest to the rivet is the Zenith number. On a small bore M/S carb, a round tag is riveted to the side of the float bowl area. In most cases, the M/S number starts out as TSX- xxx then a three number digit. ie- TSX-470. Once you ID the carb and its P/N you can get any part needed for it. If you're looking for a rebuilding kit, we have a whole wall full of em'. Just need to know what ya got. Be glad to help you out.....
Steve@B&B

Posted By: bshook78
Date Posted: 28 Sep 2012 at 4:09pm

Thanks. I am going to check it out today. I hope to find out something in a little while.

Posted By: bshook78
Date Posted: 28 Sep 2012 at 10:29pm

I found out that it is definetly a Zenith. It has a B14 on the bottom, and it has C21-78 on the disk.