7045 Rear Wheel weights
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=56137
Printed Date: 08 Sep 2025 at 12:02am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 7045 Rear Wheel weights
Posted By: Tbone95
Subject: 7045 Rear Wheel weights
Date Posted: 31 Aug 2012 at 1:11pm
| I bought some weights for a 7045. They are the solid ring style, probably ~ 3" thick, must weigh ~ 300-350 each. I want to put 2 on the left, 1 on the right. There is a 3 hole bolt circle towards the outside on the tractor as well as on the weight. There is also a 6 hole circle on the tractor and on the weight, but the on the tractor, it's a 3/4" hole for carriage bolt, but the hole in the weight must be 1 3/4 or 2". . .How do you mount these securely? |
Replies:
Posted By: Chad (MN)
Date Posted: 01 Sep 2012 at 9:27am
|
I'll take a stab at this one...... Use the outer three holes. The inner six holes are larger so you can put the 3/4 carriage bolts through to the outside of the casting for section weights or the flower-pot style dual hubs. Anyone else help on this one?? ------------- 220 3-190XT 2-D19d D19g 5-D17 UC 3-WC 2-WD 3-WD45 CA C H3 7-AllCrops 14-plows 3-Gleaners Lawnmowers SC-equipment |
Posted By: 7060
Date Posted: 01 Sep 2012 at 9:43am
If these are the weights your talking about I think the only way there supposed to go is on the inside of the wheel. I mounted mine with the 3 3/4" bolts.
|
Posted By: Tbone95
Date Posted: 04 Sep 2012 at 7:26am
|
Thanks guys and esp. 7060 for the picture. It looks like you have 2 weights mounted there, correct? I was hoping to put those on the outside, but if they're inner weights, that's what I'll do. I did not know that. Would be a tight squeeze getting the dual clamps in there, but thought it might have worked. So, if you could confirm there's room for 2?
|
Posted By: 7060
Date Posted: 04 Sep 2012 at 11:29am
| Yes, I have 2 on each side. I think the operators manual says you can put 3 on each side. |
Posted By: Tbone95
Date Posted: 04 Sep 2012 at 12:17pm
| Thanks so much 7060. That's exactly what I have and what I needed to know. |
Posted By: Wes (VA)
Date Posted: 04 Sep 2012 at 12:53pm
| I have a 7080 with 3 on each side...they fit but its close between the weight and the axle. -Wes |