Farm Equipment - ot !! woods hd 315

Print Page | Close Window

ot !! woods hd 315

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=55361
Printed Date: 09 Sep 2025 at 5:50pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: ot !! woods hd 315

Posted By: XT in pa
Subject: ot !! woods hd 315
Date Posted: 16 Aug 2012 at 5:23pm

im using my neighbors batwing mower and the shaft on the wing (right side) pulled out of other shaft and i found a broken 3/8 roll pin. i got a new pin but cant find out where it was put together at, there is a spring on outside of gearbox and the two shafts slide together and im guessing the roll pin holds the shaft from sliding out ? butwhere does roll pin go ???

Shawn

-------------
190XT,D17and 7045

Replies:

Posted By: Hurst
Date Posted: 17 Aug 2012 at 2:00pm

If you're talking about the square shaft that slides all the way through the wing gearbox, it will go through the square shaft just before the end. It should have a roll pin-washer-spring on the outside of the gearbox (side closest to the wing edge). It may be a spirol pin, I can't remember since we got rid of our b320 a few years ago. Generally this is caused by long shaft (the actual PTO shaft between the wing gear box and the center box) being rusty inside and not sliding smoothly when lowering the wings.

Here's a good picture of one:

http://www.purplewave.com/cgi-bin/mnlist.cgi?120425/B3163/10" rel="nofollow - http://www.purplewave.com/cgi-bin/mnlist.cgi?120425/B3163/10

Hurst

-------------
1979 Allis Chalmers 7000
5800 Hours