model c 1941 row crop front post bearing
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=54035
Printed Date: 11 Sep 2025 at 3:34am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: model c 1941 row crop front post bearing
Posted By: splattman29
Subject: model c 1941 row crop front post bearing
Date Posted: 23 Jul 2012 at 9:21am
|
is this bearing adjustable? i am having a vibrating problem. tires shake all over in 3rd gear when i hit a bump, i am new to the game any help very much appreciated here , i checked wheel bearing's and the bar from the steering box to the front end needs to be replaced it has been lets say hit with a hammer to give it a few extra days of life ,lol. thank you new proud owner of this model c 1941 :)
|
Replies:
Posted By: CTuckerNWIL
Date Posted: 23 Jul 2012 at 9:35am
There are shims in the vertical spindle. There are also shims between the pedestal and the front support housing . If one is change the other may need adjusted.
-------------
http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF
|
Posted By: Chalmersbob
Date Posted: 23 Jul 2012 at 9:53pm
|
The upright pedestal is bolted to the gearbox with 4 cap screws. There are both paper and steel shims located between the 2. You must remove shims to tighten your steering. When reinstalling use 1 paper and then 1 steel. Remove enough shims tO eliminate backlash, but not too many to cause it to be tight. When reinstalling the pedestal have the steering in the forward position and the front wheels to match, to get timing correct. LOL Bob
|
|