Farm Equipment - D14 governor rod linkage spring

Print Page | Close Window

D14 governor rod linkage spring

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=53683
Printed Date: 11 Sep 2025 at 8:24am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: D14 governor rod linkage spring

Posted By: sdailey
Subject: D14 governor rod linkage spring
Date Posted: 16 Jul 2012 at 8:28am

Could somebody tell me or send me a picture of where the spring on the linkage rod from the governor that connects to the carberator goes on my D14? I see the hole in the rod where the spring connects to it but have no idea where to hook the other end of the spring.

Thanks!!!!

Replies:

Posted By: DSeries4
Date Posted: 16 Jul 2012 at 10:29pm

The spring goes from the hole in the rod to one of the manifold studs that are above it.

-------------
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080

Posted By: Chalmersbob
Date Posted: 17 Jul 2012 at 9:50pm

While we are on the subject. On mine the hole is too far front in the rod to connect to a manifold stud. The spring wraps around the bottom of the manifold and doesn't allow the engine to idle. Any suggestions.

Thanks Bob