D14 Bearings
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=49691
Printed Date: 20 Aug 2025 at 9:55pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: D14 Bearings
Posted By: Scott(SC)
Subject: D14 Bearings
Date Posted: 27 Apr 2012 at 6:10pm
| I'm replacing the rod and main bearings on my D14. Does anyone know the torque on the caps and the acceptable oild clearance? |
Replies:
Posted By: CTuckerNWIL
Date Posted: 27 Apr 2012 at 8:14pm
|
Rod bearing clearance ..0.0006-0.0027 Rod nut torque (Ft.-Lbs.) ....35-40 Main bearing oil clearance is 0.002-0.004. Install inserts with projections engaging the machined slots and with slots in cap and block on the same side of engine. Bearing cap retaining cap screws should be tightened to 90-95 Ft.-Lbs. of torque. ------------- http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |
Posted By: Chalmersbob
Date Posted: 27 Apr 2012 at 9:18pm
|
My service manual list the rod bearings at .001-.003
also lock nut torque 40-60 inch lbs.
Bob
|
Posted By: Scott(SC)
Date Posted: 28 Apr 2012 at 7:31am
|
I'm within tolerance then. On the torque, I was guessing 45 on the rods and 100 on the mains, so I should be alright. Did the mains and 1 rod yesterday and a storm blew in. Thanks guys.
|
Posted By: Scott(SC)
Date Posted: 30 Apr 2012 at 8:08pm
| I finished the bearings this evening and went for a ride. 20 pounds of pressure and quiet. I happy now! |
Posted By: CTuckerNWIL
Date Posted: 30 Apr 2012 at 10:20pm
------------- http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |