7040
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=48626
Printed Date: 25 Aug 2025 at 11:44am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 7040
Posted By: mogle
Subject: 7040
Date Posted: 07 Apr 2012 at 9:35pm
|
does any one know how to get to the scavenger pump on a 7040
|
Replies:
Posted By: MACK
Date Posted: 07 Apr 2012 at 10:08pm
|
If it has one, take the plate off bottom of torque tube just behind engine. MACK
|
Posted By: DrAllis
Date Posted: 08 Apr 2012 at 5:34am
|
Why do you think you need to get at the scavenger pump??
|
Posted By: mogle
Date Posted: 08 Apr 2012 at 1:27pm
|
found alot of metal in the oil and has a lot of noise somewere in the hydrolics and cheacking to make sure all of the four pumps are good
|
Posted By: DrAllis
Date Posted: 08 Apr 2012 at 3:16pm
|
A lot of metal in the rearend/hydraulic oil ???? or transmision oil??? where did you find the metal??
|
Posted By: mogle
Date Posted: 10 Apr 2012 at 11:39am
Posted By: DrAllis
Date Posted: 10 Apr 2012 at 6:43pm
|
The hydraulic oil comes from the rearend. The Scavenge pump is in the front of the transmission.
|
Posted By: mogle
Date Posted: 11 Apr 2012 at 12:41pm
|
yes but all of the oil is shared
|
Posted By: Orange Blood
Date Posted: 11 Apr 2012 at 2:22pm
Actually Mogle, I am fairly certain that is not correct. There is a trans dipstick in the front, in the cab, and a rear end sight gauge on the back left, and two different filters, and two different fill points. I would have to go pull my hydraulic flow charts, but I think the scavenger pump charges the two pumps most rearward, and the front pump is the hydraulic pump, and only the hydraulic pump pulls from the rear, but again I have to get out the books
-------------
Still in use:
HD7 WC C CA WD 2-WD45 WD45LP WD45D D14 3-D17 D17LP 2-D19D D19LP 190XTD 190XTLP 720 D21 220 7020 7030 7040 7045 3-7060
Projects: 3-U UC 2-G 2-B 2-C CA 7-WC RC WDLP WF D14 D21 210 7045 N7
|
Posted By: Jordan(OH)
Date Posted: 11 Apr 2012 at 4:28pm
Posted By: Mike Kroupa
Date Posted: 11 Apr 2012 at 7:34pm
|
Scavenger pump was used to return "scavenge" oil from power director clutches to the trans. housing. It was eliminated with the black belly pd tractors in favor of a gravity return system, I think early models could be updated. The gear pump charged the axial piston hyd. pump. hth, Mike
|
Posted By: mogle
Date Posted: 12 Apr 2012 at 6:57pm
|
o well it just seemed that it is shared because a pip comes from the gear geroter pump to were the scavenger pump is but yoo maybe right
|
|