Farm Equipment - G Fan shaft Bearing Removal

Print Page | Close Window

G Fan shaft Bearing Removal

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=47137
Printed Date: 31 Oct 2025 at 9:51am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: G Fan shaft Bearing Removal

Posted By: Allis Barn
Subject: G Fan shaft Bearing Removal
Date Posted: 12 Mar 2012 at 4:57pm

I have read the Service Manual on remving the fan and the pulley so that the two bearings can be removed. But that does not seem to work. both the fan and the pulley are too light weight stand up to a gear puller.

Any suggestions? Need to replace both bearing .

thanks

Bob

Replies:

Posted By: Warren(Oh)
Date Posted: 12 Mar 2012 at 5:08pm

They have to be pressed off and on. I didn't get to watch when mine were removed last year. NAPA shop did mine.

Posted By: Chalmersbob
Date Posted: 12 Mar 2012 at 11:25pm

you need a "split bearing puller attachment". It clamps on behind the pulley and you attach your puller to it so the pulley is not damaged. I applies even pressure all around the circumference. Bob

Posted By: Allis Barn
Date Posted: 18 Mar 2012 at 9:50pm

Thanks Warren and Bob. Had to use the advise of each. Pulley end bearing and pulley came off with a gear puller and split bearing puller. Had to have a press for the fan and the fan end bearing. Took ten tons of pressure and the fan hub heated cherry hot.

However the new bearings sure do reduce the engine nosie level.

Thanks

Bob @ Allis Barn

PS Know of anyone having a used G hood for sale. Mine has been cut and modified