Farm Equipment - I have a few 190XT questions.

Print Page | Close Window

I have a few 190XT questions.

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=46933
Printed Date: 29 Aug 2025 at 5:34pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: I have a few 190XT questions.

Posted By: Gary (sw Wis.)
Subject: I have a few 190XT questions.
Date Posted: 09 Mar 2012 at 8:05am

I have no Hi Range on the Power Direct at all. Where do I start checking things?

Where can I buy the tach cable. And how much?

How do I test the temperature sending unit.

Are the clamps that hold down the battery deck plate and hold the grill cover available?

Thanks

-------------
190XT - D17 - D14 - WD45 w/loader - WD - (2)B110 - 616H - 610 - B-208 - WD with 190 Mounted Corn Picker - All Crop 60

Replies:

Posted By: Austin(WI)
Date Posted: 09 Mar 2012 at 8:13am

PD: Does the tractor even move when you put it in High Range?

Tac Cable: You can find those either on retailers on here or Through AGCO ( Usually between $20-$40)

Temp: Take the little wire plug end off and ground that cable somewhere on the tractor. If the needle on the gauge gets burried the sending unit in the block is bad. If the gauge doesn't do anything then gauge is bad, but you sending unit might be bad too.

Latches: Grill cover ones are available, but I believe are either $20 or $30 per latch through AGCO. Not sure about the battery box lid.

-------------
"Better By Design"

Posted By: Austin(WI)
Date Posted: 09 Mar 2012 at 8:19am

You might have to split the tractor to fix the PD. Worn disc plates could be the issue. Only fixed a couple PDs and that is what needed to be replaced.

-------------
"Better By Design"

Posted By: tractorman
Date Posted: 09 Mar 2012 at 8:25am

we had a problem with both the high and low , first we checked drained and replaced the hydrofluid for it , it was low and works fine now. So check it first if you haven't already .

-------------
Play on 38 B 49 WF , working on D14, D15 B10, Bee 12 B110. use 185 and 190

Posted By: Austin(WI)
Date Posted: 09 Mar 2012 at 8:58am

Yea, def. helps to have some oil in it. On our D19 the who PD was warped or something.

-------------
"Better By Design"

Posted By: DaveCinIN
Date Posted: 09 Mar 2012 at 8:59pm

Check the PD control valve. Mine had a snap ring pop off so the rod was moving but not the piston. Put new snap ring on and good as new. Not sure on the others.

Posted By: Gary (sw Wis.)
Date Posted: 12 Mar 2012 at 8:16am

Bump.... Thank for the responses guys I hope to get back to it this some time.

-------------
190XT - D17 - D14 - WD45 w/loader - WD - (2)B110 - 616H - 610 - B-208 - WD with 190 Mounted Corn Picker - All Crop 60