Farm Equipment - Removing throw bearing???

Print Page | Close Window

Removing throw bearing???

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=38726
Printed Date: 18 Sep 2025 at 12:25pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Removing throw bearing???

Posted By: Brampton 02 gt
Subject: Removing throw bearing???
Date Posted: 10 Oct 2011 at 8:38pm

I am doing the clutch on my WD45 - how do I reomove the throw bearing. There appears to be a spirng holding onto the grease nipple. Do I just unhook the spring? How do I know which way to put the new bearing on - front to back of bearing?

thanks.

Replies:

Posted By: MACK
Date Posted: 10 Oct 2011 at 8:54pm

Yes remove spring and bearing and carrier will slide off.

The new bearing goes on with wides flat surface to engine. MACK

Posted By: Chris/CT
Date Posted: 11 Oct 2011 at 5:03am

I'm late with this post, but I have a nice Rebuilt PP [9 spring] and Clutch disc [ rebuilt w/ original NOS AC facings ready to install ] for your 45. PM if you haven't purchased yet.

Posted By: B26240
Date Posted: 11 Oct 2011 at 7:17am

Chris has a good point, make sure you use the 9 spring plate, WD's and WC's only had a 6 spring plate and they will fit but won't take the HP