WD Shifter again
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=37448
Printed Date: 05 Oct 2025 at 3:28pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: WD Shifter again
Posted By: Tim in MN
Subject: WD Shifter again
Date Posted: 17 Sep 2011 at 11:28pm
|
Guys, please excuse my ignorance on this matter, but this is the first time I've worked on the WD shifter problem. I have some more questions.
In the parts and service manuals they show only one snap ring to hold the shift lever into the shifter tower, mine had two snap rings, and the shifter was still loose, can I assume that the tower is worn beyond use?
When installing the shift rod into the tower, I assume all the lugs on the shifter forks should be lined up, and the trans gears in line with the shifter forks, then install the top back on the trans? Or do I have the sequence wrong?
I have to order a new shifter washer and snap ring, maybe a shifter tower, should I also get a new over sized pivot pin and file to fit, the old one fits fine.
Any and all help will be greatly appriciated. Thanks, Tim.
|
Replies:
Posted By: David(Stockbridge)MI
Date Posted: 18 Sep 2011 at 7:54am
all three  rails in center condition, then install shift handle washer then snap ring, may require 2nd snap ring to take up play.------------- All "NEW" Web Site http://www.djstractorparts.com 2035,A,U,UC,WF unstyled,WF styled,WC High Crop (cane),RC,B,IB,C,CA,WD,WD45,G,D10,D12,D14,D15,D15 II,D17,D19,WC styled,WC unstyled H3 crawler |
Posted By: MACK
Date Posted: 18 Sep 2011 at 8:12am
| It is easer to put top on first then install gear shift. MACK |