Zenith carb help
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=35786
Printed Date: 31 Oct 2025 at 6:42am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Zenith carb help
Posted By: LouSWPA
Subject: Zenith carb help
Date Posted: 20 Aug 2011 at 12:36pm
|
Anybody have an idea what the proper float heigth should be for a 9 00 12522? I believe this is a universal replacement carb, and the rebuild instructions don't address specs for it. Instructions give settings for series 61, 62, 67, 68, 161, 267, 63, 63M, 263M, but I do not know which this carb is equivalent to. I was just going to pick one and try it, but there is quite a span in the numbers ------------- I am still confident of this; I will see the goodness of the Lord in the land of the living. Wait for the Lord; be strong and take heart and wait for the Lord. Ps 27 |
Replies:
Posted By: Jeff Z. NY
Date Posted: 20 Aug 2011 at 12:45pm
|
Lou, There may be info in this that could help you.
Go to page 15 for the start of the Zenith section. http://l-36.com/carb.pdf ------------- I Love Meatballs and Dumplings on Toast with Gravy and Rosemary and ??? {Open For Suggestions} |
Posted By: Dick L
Date Posted: 20 Aug 2011 at 1:29pm
Turn it upside down and make sure the floats are parallel with the base and it will be close enough. I have not measured one in years.
 |
Posted By: LouSWPA
Date Posted: 20 Aug 2011 at 1:32pm
|
Thanks guys! Dick, after perusing over the site Jeff posted, I noted the specs for tolerance were pretty wide! I think I have a game plan now. Back to the "shop" ------------- I am still confident of this; I will see the goodness of the Lord in the land of the living. Wait for the Lord; be strong and take heart and wait for the Lord. Ps 27 |