Farm Equipment - Model G PTO

Print Page | Close Window

Model G PTO

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=24471
Printed Date: 19 Jul 2025 at 4:44pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Model G PTO

Posted By: Scott(GA)
Subject: Model G PTO
Date Posted: 21 Jan 2011 at 7:49pm

I came across a G in a shed today. It has a regular PTO shaft with a V-Belt pulley on it. I tried turning the pulley with my hand but it was frozen in place. I'm sure it's possible for the PTO to be "frozen" but, if that wasn't the case, could the engine be frozen?

It's my impression that if the engine is running, the PTO is turning on a G. ...is that correct?

Is there anything about this G's engine that can be inferred by the PTO not wanting to move?

Scott

Replies:

Posted By: Eldon (WA)
Date Posted: 21 Jan 2011 at 8:18pm

Did you try disengaging it?

-------------
ALLIS EXPRESS!
This year:

Posted By: CTuckerNWIL
Date Posted: 21 Jan 2011 at 8:24pm

If it has a hydraulic pump it can be disengaged from the engine. If it doesn't have the hydraulic, I think it is direct of the engine.

-------------
http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF

Posted By: JoeM(GA)
Date Posted: 21 Jan 2011 at 8:49pm

Any time the clutch is out, the pto is engaged. So even with the engine off, unless the pedal is locked down it's not going to turn

-------------
Allis Express North Georgia
41 WC,48 UC Cane,7-G's,
Ford 345C TLB

Posted By: Scott(GA)
Date Posted: 21 Jan 2011 at 8:50pm

It did not have a hydraulic pump.

Scott

Posted By: Chalmersbob
Date Posted: 21 Jan 2011 at 9:17pm

the shaft is at a right angle to the engine crankshaft, therfore it will not turn the engine very easy. It's not like a B which is in a straight line. Bob