Farm Equipment - D10/12 Loader

Print Page | Close Window

D10/12 Loader

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=24456
Printed Date: 19 Jul 2025 at 2:06am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: D10/12 Loader

Posted By: Jim-Ohio
Subject: D10/12 Loader
Date Posted: 21 Jan 2011 at 2:39pm

Would this loader work on a CA?

http://cgi.ebay.com/Allis-Chalmers-D10-D12-D14-Hydraulic-Loader-/270695734497?pt=LH_DefaultDomain_0&hash=item3f06b91ce1 - http://cgi.ebay.com/Allis-Chalmers-D10-D12-D14-Hydraulic-Loader-/270695734497?pt=LH_DefaultDomain_0&hash=item3f06b91ce1

-------------
'61D17, '51WD, '51CA, '41C, '49C, Woods 5'&6'Mower, 6'Blade, CA-Plow, CA-Cultivator, 3-Btm snap-coupler plow, 4-row planter, WD 4-row cultivator, 80R mower,#7 mower,B/C mower

Replies:

Posted By: AC WD45
Date Posted: 21 Jan 2011 at 2:44pm

it may fit but it's fully hydraulic. Your CA is meant for a trip bucket loader. You would also need to retro fit the brackets.

-------------
German Shepherd dad
1957 Allis Chalmers WD45
#WD234847
1951 Allis Chalmers WD
#WD88193

Posted By: John (MO)
Date Posted: 21 Jan 2011 at 7:23pm

There is only one hose to each cylinder, I believe those cylinders are one way. Should fit with a little work on the mounts. I doubt you will find mounting holes that line up on a CA, so it will require some shop work.

Posted By: RMD
Date Posted: 22 Jan 2011 at 10:41am

I'm pretty sure that you would have to fabricate brackets for the mounts on the side of the engine, probably mounting to the same points as CA cultivators. Also the seat on the CA is a lot farther back to the rear of the tractor, so you would have to re-locate the controls so you can reach them from the operator's seat.