B/C & WC
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=206978
Printed Date: 06 Jun 2025 at 4:28pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: B/C & WC
Posted By: Unit3
Subject: B/C & WC
Date Posted: 04 Jun 2025 at 10:10am
|
Do they share the same bolt hole patterns on the rear of the engine to the bell housings? ------------- 2-8070FWA PS/8050PS/7080/7045PS/200/D15-II/2-WD45/WD/3-WC/UC/C |
Replies:
Posted By: PaulB
Date Posted: 04 Jun 2025 at 7:54pm
|
NO. However there was some kind of Rube Goldburg rig for the prototype the Allis Engineers did to put the 201 engine into a B. ------------- If it was fun to pull in LOW gear, I could have a John Deere. Real pullers don't have speed limits. If you can't make it GO... make it SHINY |
Posted By: AaronSEIA
Date Posted: 05 Jun 2025 at 5:42am
|
No. The B engine has an adapter to fit the WC bellhousing when they made the RC. AaronSEIA
|
Posted By: PaulB
Date Posted: 05 Jun 2025 at 6:50am
NO it does not. The RC tractor has two different sets of hole that the B/C engine uses one set to bolt to the bell housing. Now the front support is unique to the RC tractor allowing the B/C engine into the WC frame rails. ------------- If it was fun to pull in LOW gear, I could have a John Deere. Real pullers don't have speed limits. If you can't make it GO... make it SHINY |
AaronSEIA wrote: