plastic hugger snout points
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=204324
Printed Date: 07 May 2025 at 9:11pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: plastic hugger snout points
Posted By: SteveM C/IL
Subject: plastic hugger snout points
Date Posted: 27 Nov 2024 at 8:30pm
| Anyone know if the points are cast steel or cast iron? Could plate them if they can be welded on. $50 bucks + - |
Replies:
Posted By: 8070nc
Date Posted: 28 Nov 2024 at 8:57am
|
If I had to guess id say they are steel. Strike an arc with a 7018 rod and you will know pretty quick If the weld lays dowm they are steel. If it bubbles up they are cast ------------- 1984 80780 1957 D14 DES 300 with 25000 engine 616 tractor |
Posted By: ryan(IN)
Date Posted: 29 Nov 2024 at 8:58am
|
Yes they are cast. ------------- ryan 1984 8070 FWA,1979 7060,1975 7040,1971 190,1960 D-17D,1957 D-14, 196? D-19G, 1975 5040,1971? 160,1994 R62 |
Posted By: Leon B MO
Date Posted: 29 Nov 2024 at 11:27am
|
Shoup catalog has them, new also. Leon B ------------- Uncle always said "Fill the back of the shovel and the front will take care of itself". |
Posted By: Unit3
Date Posted: 29 Nov 2024 at 10:05pm
|
I braised welded one back together years ago. ------------- 2-8070FWA PS/8050PS/7080/7045PS/200/D15-II/2-WD45/WD/3-WC/UC/C |
Posted By: SteveM C/IL
Date Posted: 30 Nov 2024 at 9:32am
I can see they are a casting. The question was cast what? Iron or steel?
|
ryan(IN) wrote:Posted By: ryan(IN)
Date Posted: 30 Nov 2024 at 10:44am
|
The note in my system at work says cast point for steel use 71364963V. But that part number supersedes back to 71364963 without the v that just says cast point. I’d assume cast iron. ------------- ryan 1984 8070 FWA,1979 7060,1975 7040,1971 190,1960 D-17D,1957 D-14, 196? D-19G, 1975 5040,1971? 160,1994 R62 |
Posted By: Amos
Date Posted: 03 Dec 2024 at 2:54pm
| I welded AR steel plates on the bottom of a set of mine on a steel snout hugger head. I used ER70SD4 wire in my MIG, they"re still on the head today |