One Ninety power director valve
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=199817
Printed Date: 03 Oct 2025 at 5:18pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: One Ninety power director valve
Posted By: DPKII
Subject: One Ninety power director valve
Date Posted: 14 Feb 2024 at 1:37pm
|
My power director valve on the One Ninety is leaking around the plunger. I have a new seal to replace the old one but before I attempt to repair I would like to have the internal valve to tractor seals so that I can replace them. The seals/orings/washers in question are #2 and #3 in the diagram. The part numbers listed are #2 0209734-3 washer valve cover, and #3 0247301-5 Gasket valve. I have searched using these numbers but cannot find a parts source. Would anyone happen to know a universal part number or size? Something that I can order from Mcmaster Carr or similar?  |
Replies:
Posted By: Lynn Marshall
Date Posted: 14 Feb 2024 at 4:53pm
| That parts number list is not corresponding with the picture. There's another list of numbers that aren't shown in the picture. |
Posted By: SilverShoes
Date Posted: 14 Feb 2024 at 5:36pm
| Are those just rubber orings or a special sealing gasket |
Posted By: Lynn Marshall
Date Posted: 14 Feb 2024 at 6:02pm
| It uses a gasket and O rings. 70247301 gasket. 1 of #70923846, 1 of #70923565. 2 of#70923560, 2 of#70923663. The seal is #70243321. Some of the O rings go into grooves in the valve body and the others just slide over the exposed tubes. |
Posted By: DPKII
Date Posted: 15 Feb 2024 at 7:50am
|
Lynn, Thanks for the parts numbers and for the clue that the page of numbers I had did not match the diagram. It was the first page after the diagram and I assumed it was correct and the descriptions were close enough for the orings that I didn't think otherwise. Next page in the book looks to have the correct parts with sizes. It was right it front of me but didn't click! Thanks again for the help....  |