F2 motor into a d19.
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=190034
Printed Date: 22 Oct 2025 at 12:21am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: F2 motor into a d19.
Posted By: Valleyfarmanddiesel
Subject: F2 motor into a d19.
Date Posted: 12 Aug 2022 at 2:29pm
| Has anyone on here replaced a d19 gas motor with a gleaner f2 motor? Having trouble with the starter. Not sure if I need to swap ringgears, starters or if it's even possible. Had to use the gas flywheel that is set for a 9 tooth small drive and the f2 is set for a 10 tooth 40mm drive. Let's just say the ten engages but locks her up tight. I am finding this was a bad idea but am stuck finishing it. |
Replies:
Posted By: MACK
Date Posted: 12 Aug 2022 at 9:27pm
| I would bet (Steve In NJ) on here can fix you up with the right drive. MACK |
Posted By: Valleyfarmanddiesel
Date Posted: 15 Aug 2022 at 9:09pm
| Going to pull the motor again and see if I can swap the ring gears. Hope I works. Went to a couple starter shops and no luck. Tried to look up Steve in NJ but no luck. Thanks mack |
Posted By: steve(ill)
Date Posted: 15 Aug 2022 at 9:17pm
Steve might not be able to FIX... but he sure could fill you in on possibilities... ------------- Like them all, but love the "B"s. |
Posted By: 8070nc
Date Posted: 15 Aug 2022 at 9:19pm
|
B&b custom circuits on the web ------------- 1984 80780 1957 D14 DES 300 with 25000 engine 616 tractor |