Cylinder sleeve protrusion
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=186016
Printed Date: 28 Apr 2024 at 10:09pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Cylinder sleeve protrusion
Posted By: Kddrck
Subject: Cylinder sleeve protrusion
Date Posted: 25 Jan 2022 at 12:08pm
| I'm rebuilding the engine on a model C. We had to mill the top of the engine block. My question is how far above the block should the new cylinder protrude? |
Replies:
Posted By: steve(ill)
Date Posted: 25 Jan 2022 at 12:29pm
.002 - .004 inch .............. look close at the rods on the pistons.. They are offset as you install on the crank... two of them point different than the other two... ------------- Like them all, but love the "B"s. |
Posted By: Kddrck
Date Posted: 25 Jan 2022 at 1:38pm
| Thank you. |