Print Page | Close Window

brake labor

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=185331
Printed Date: 25 Aug 2025 at 10:07pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: brake labor
Posted By: edmo
Subject: brake labor
Date Posted: 25 Dec 2021 at 3:49pm
This has  obviously been discussed on here before but I cant run it down.  i WAS going to replace the brakes on my 180 myself until  Santa dropped my lump of  coal from the sleigh and hit my head and put me out of commission.  I know the job comes with uncertainties , but  can somebody give me an idea OF the range of labor costs involved that i might expect



Replies:
Posted By: DiyDave
Date Posted: 25 Dec 2021 at 4:43pm
Here's a 5 year old topic that may shed some light:

https://www.allischalmers.com/forum/185-brake-job-cost_topic115444.html" rel="nofollow - https://www.allischalmers.com/forum/185-brake-job-cost_topic115444.html

I have some I & T blue books, if I can find them, tomorrow, and if I remember!Wink


-------------
Source: Babylon Bee. Sponsored by BRAWNDO, its got what you need!


Posted By: DMiller
Date Posted: 25 Dec 2021 at 5:03pm
Need some serious block cribbing, remove the rear wheel assemblies, remove the axle tubes and then can start the Brake Job.


Posted By: Fred in Pa
Date Posted: 25 Dec 2021 at 5:10pm
Been doing these for 40 years  always pull wheel and axle together 

-------------
He who dies with the most toys is,
nonetheless ,still dead.
If all else fails ,Read all that is PRINTED.


Posted By: DrAllis
Date Posted: 25 Dec 2021 at 6:31pm
When I was much younger, I would flat rate both sides at 8 hrs.  Torch work was extra as was a cab or roll bar.


Posted By: DSeries4
Date Posted: 25 Dec 2021 at 8:52pm
Changing the brakes can be done pretty quick.  All the time comes from removing and reinstalling the axle and wheel.  I have done several in recent years, so I am getting better at it.


-------------
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net