Farm Equipment - 7000 ps end cap

Print Page | Close Window

7000 ps end cap

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=176747
Printed Date: 02 Oct 2025 at 12:10am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 7000 ps end cap

Posted By: tnboss
Subject: 7000 ps end cap
Date Posted: 14 Dec 2020 at 9:51am

Replacing the low range clutches in my 7000, Has wore grooves in the heavy end plate, can I polish the other side up and flip over afraid grooves will ruin new friction plates. Thanks for any help.

Replies:

Posted By: NEVER green
Date Posted: 14 Dec 2020 at 10:57am

Dont see why not, I did on my 7040.

-------------
2-8050 1-7080 6080 D-19 modelE & A 7040 R50

Posted By: DrAllis
Date Posted: 14 Dec 2020 at 11:59am

I think I would grind the damaged side to smooth. I don't think the front face was ever finished off, was it ??

Posted By: Hurst
Date Posted: 18 Dec 2020 at 8:02pm

Check for flatness too. Mine was warped when I rebuilt mine. If you’re working on a black belly that uses it as an inching clutch, they take a beating. In all honesty, if I was doing it again and didn’t find a good low hour used clutch pack, I would get a quote from a local machine shop to make one. I don’t remember there being much complicated about them.

Hurst

-------------
1979 Allis Chalmers 7000
5800 Hours

Posted By: DrAllis
Date Posted: 18 Dec 2020 at 8:05pm

There may be room enough to make it 1/8" thicker, which would help with warpage over time. Machine it down at the O.D. to still use the same bolts, but thicker where the heat actually is.