Farm Equipment - Splitting 180, tips?

Print Page | Close Window

Splitting 180, tips?

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=175255
Printed Date: 05 Apr 2026 at 10:46am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Splitting 180, tips?

Posted By: DMiller
Subject: Splitting 180, tips?
Date Posted: 18 Oct 2020 at 11:59am

Splitting 180

Break at PD or Trans First? Need to reclutch PD(Drags non stop in N) and should replace engine clutch/throw out bearing(Just feel is time), also have a Hyd to Trans cross leak beginning(PTO Seal).

Replies:

Posted By: DougG
Date Posted: 18 Oct 2020 at 1:03pm

This is what I do - right or wrong - is strip it all down , i use a chain hoist and hook it to the engine , block up the rear end at drawbar support, may have a floor jack handy, then do the PD clutch assembly, pto seals should be easy to replace then, roll that back together, then break it at the rear of the engine adapter plate/ PD housing / frame rails and roll the engine and front assembly forward then remove the pressure plate , clutch and flywheel and take that to Rick C - at his clutch shop in Jonesburg,, just the way i do it

Posted By: Rick
Date Posted: 18 Oct 2020 at 1:08pm

Dave...I can do the clutch unit for you and you can drop it off at my house at 209 Hill Lane in Jonesburg, MO. and I'll take it from there. Allow about three to four days to get it done and I'll let you know...call me at 314-488-9224...Thanks, Rick

Posted By: DMiller
Date Posted: 18 Oct 2020 at 6:05pm

Thanks Guys, am writing this down, will get back on this after get the KW Done!! The 180 has to be functional at least for a few months yet. At which time it becomes the 'Project'!!