char-lynn seal kit
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=174165
Printed Date: 08 Jun 2025 at 5:42am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: char-lynn seal kit
Posted By: mhankins
Subject: char-lynn seal kit
Date Posted: 07 Sep 2020 at 8:25am
|
I am looking for a seal kit source for the torque multiplier on my wd45. So far all I have found are the seal kits for the pump,but mine is leaking out of the lower seal where the steering shaft connects.
|
Replies:
Posted By: Play Farmer
Date Posted: 07 Sep 2020 at 8:52am
| Measure the seal and you should be able to find one on line pretty easy. |
Posted By: DSeries4
Date Posted: 07 Sep 2020 at 9:06am
|
A local hydraulic shop should have what you need. ------------- '49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080 |
Posted By: Michael V (NM)
Date Posted: 07 Sep 2020 at 4:54pm
|
Try this Eaton power products No.21122 I ordered this from Force America several years ago, its a complete seal kit, with instructions on how to "time" the gears.. |
Posted By: mhankins
Date Posted: 08 Sep 2020 at 8:56am
|
Thanks Michael. I couldn't find that part number listed,but I will contact the company. |
Posted By: Michael V (NM)
Date Posted: 08 Sep 2020 at 11:14am
here ya go  |
Posted By: mhankins
Date Posted: 08 Sep 2020 at 3:16pm
|
Thank you! |
Posted By: mhankins
Date Posted: 09 Sep 2020 at 9:38am
|
Midwest steering has the seal kits if anyone else is looking. |
Posted By: mhankins
Date Posted: 10 Nov 2020 at 8:44am
|
HELP!! Ok,finally got around to taking the multiplier off and replaced the seals,butt... when I tighten everything down it will not turn. I timed it according to the pics above and tried the spacers in each position.The coupler shaft that goes between the rotor and the out put shaft at the lower part has different thickness splines on either end and I have tried those in each position. This is a series 101 which shows a little difference than the one pictured as to how many seals are used as mine doesn't have the larger orings sealing the case and spacers. Any Ideas?
|
Posted By: mhankins
Date Posted: 10 Nov 2020 at 5:47pm
|
Never mind,got it going |
Posted By: SteveM C/IL
Date Posted: 10 Nov 2020 at 8:13pm
Want to fess up ?
|
mhankins wrote:Posted By: mhankins
Date Posted: 11 Nov 2020 at 7:39am
|
Put it together from the bottom up instead of the top down. ??? worked
|