WC rod bolts
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=167941
Printed Date: 22 May 2025 at 11:31am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: WC rod bolts
Posted By: randy
Subject: WC rod bolts
Date Posted: 01 Feb 2020 at 6:19pm
|
I am wondering what is the proper way to torque the rod bolts. the rods have been honed to use regular bearings, no shims, and the nuts are castle headed. When i torque them to 70 ft lbs none of the holes line up for a cotter pin. The I&t manual doesnt give much help, Do i torque to 60 ft lbs and tighten them up till i can get a pin in? Thanks, Randy ------------- CA WD WD45 D17 D17 Diesel 7060 8050 8070 |
Replies:
Posted By: Jacob (WI,ND)
Date Posted: 01 Feb 2020 at 7:51pm
|
I don't have an answer for you, but one trick I learned along the way for a situation where you need a castle nut to line up at a specific torque, and it isn't, is to try a different one of your nuts. They are not all exactly the same, so if you try another one of the nuts usually it will line up with one of the holes. I would think if your torque is a *slight* bit either way you should be ok too. We're not building race engines here after all, LOL! But I'm sure someone who knows more about engine building will chime in. ------------- Jacob Swanson 1920 6-12; 1925,1926 20-35 longfenders; 1925,1926 15-25's; 1927,1929 20-35 shortfenders; C; B's; IB; WC's; WD; WD45 |
Posted By: Rick of HopeIN
Date Posted: 01 Feb 2020 at 8:01pm
|
I looked at several, posts. Finally settled on 50 ft-lb then lined up the hole with whatever it took. Usually I got lucky but I end up backing up one a little more than I wanted. Never thought about trying another nut, good tip. ------------- 1951 B, 1937 WC, 1957 D14, -- Thanks and God Bless |
Posted By: MACK
Date Posted: 01 Feb 2020 at 9:19pm
| Torque to 50 ft lb then throw cotter keys in trash can. Old technology. MACK |
Posted By: Boss Man
Date Posted: 02 Feb 2020 at 7:01am
| Don't need the cotter keys if properly torqued |
Posted By: IBWD MIke
Date Posted: 02 Feb 2020 at 9:01am
|
MACK wrote:Posted By: Rick of HopeIN
Date Posted: 02 Feb 2020 at 10:01am
|
I bought new ARP nuts and was thinking of locktite just for good measure. I have not bolted pan up yet but may redo mine without the cotter pins as some have said. Seemed like if the pin is very far off you either eind up with way too much torque or less than you want. 50 ft-lb seems to be prevailing theory for best torque. ------------- 1951 B, 1937 WC, 1957 D14, -- Thanks and God Bless |
Posted By: B26240
Date Posted: 02 Feb 2020 at 3:30pm
| I have found more than one of those cotter pin style nuts cracked so you did good in my opinion to replace them with new nuts. |