Farm Equipment - G226 engine main bearings D17

Print Page | Close Window

G226 engine main bearings D17

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=167192
Printed Date: 30 Aug 2025 at 4:49am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: G226 engine main bearings D17

Posted By: djake
Subject: G226 engine main bearings D17
Date Posted: 07 Jan 2020 at 10:58am

I have been looking for 0.040 Main bearings for my D17 and it seems they have been

discontinued. Does anyone know of a source for them. If not it may be time for another crankshaft.

Replies:

Posted By: Sugarmaker
Date Posted: 07 Jan 2020 at 2:10pm

djake,

Welcome! When I took my 226 WD45 crank in for work it was going to be turned to -.040. The shop recommended another better crank. He was afraid that was on the edge. We did not try to order bearings so I i dont know if they are available? Maybe try some of the suppliers her like Tony's Tractors and or Sandy Lake and others.

Good luck with your D17!

Regards,

Chris

-------------
D17 1958 (NFE), WD45 1954 (NFE), WD 1952 (NFE), WD 1950 (WFE), Allis F-40 forklift, Allis CA, Allis D14, Ford Jubilee, Many IH Cub Cadets, 32 Ford Dump, 65 Comet.

Posted By: Mikez
Date Posted: 07 Jan 2020 at 7:42pm

Does these numbers do anything

213354 and
213355 and
223626 and
204720

Posted By: Alex09(WI)
Date Posted: 07 Jan 2020 at 11:23pm

I can get .040 rod and main bearings for the WD/WD45 tractors and .040 rod bearings for the D17, but I checked today and I can't get .040 MAIN bearings for the D17/170 gas engines

-------------
www.awtractor.com
A&W TRACTOR 920-598-1287
KEEPING ALLIS-CHALMERS IN THE FIELDS THROUGH THE 21ST CENTURY

Posted By: Pfouts Family Farm
Date Posted: 07 Jan 2020 at 11:26pm

We may have some... I will try to check tomorrow and report back.

Posted By: djake
Date Posted: 08 Jan 2020 at 7:10am

I checked with the shop again today and they said it would need a 0.050

to work and I'm sure they don't make that.