6060 pto housing
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=165432
Printed Date: 09 Apr 2026 at 3:37am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 6060 pto housing
Posted By: allisrutledge
Subject: 6060 pto housing
Date Posted: 30 Oct 2019 at 11:05am
|
The hitch holes were broke out on mine when I got it and I have a good replacement housing. What do I need to look for removing it. Will the pto shaft stay with the tractor? Any advice and experience is appreciated. Scott ------------- Allis Chalmers still exist in my mind and barns |
Replies:
Posted By: LB0442
Date Posted: 31 Oct 2019 at 9:10am
Here is picture of one I did a while ago with the PTO housing removed. I did not take a picture of the PTO setup. The long shaft will stay with the housing, it slides in just above the ring gear so leave room to pull the assembly out about 2 feet. NOTE make sure you engage the PTO lever on the left side of the seat, if not the collar will fall down when you pull it apart. You do not have to take off the top 3 point shaft housing, I had that off for reseal already. I use anerobic sealer for reseal on it, the factory used silicone.
|
Posted By: allisrutledge
Date Posted: 31 Oct 2019 at 9:00pm
|
Thanks, I was thinking I needed to engage the pto clutch. ------------- Allis Chalmers still exist in my mind and barns |
Posted By: DrAllis
Date Posted: 02 Nov 2019 at 7:25am
| You need to engage the coupler disconnect to the left of the seat. If you don't do that, the coupler will fall down into the housing. |
Posted By: allisrutledge
Date Posted: 02 Nov 2019 at 7:22pm
|
Ok I reread the post thanks to both ------------- Allis Chalmers still exist in my mind and barns |