Gaskets
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=164884
Printed Date: 26 Jul 2025 at 12:10pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Gaskets
Posted By: miketothesteve
Subject: Gaskets
Date Posted: 08 Oct 2019 at 5:52am
|
My questions apply more so to a B, but could also be considered general. Are people buying gasket sheets and cutting your own, or buying pre-cut gaskets? I believe the gaskets are cork; has anyone used a different material? Does anyone know what the gasket thickness is for the B?
|
Replies:
Posted By: Allis dave
Date Posted: 08 Oct 2019 at 6:32am
|
I usually buy gaskets, but I've also made some. There are a couple for my WD45 that I couldn't find so I made. I made some cork ones for my skid steer last year. There a big cover on each side for the chain drives. Case wanted like $30 per side, so I bought a roll of cord for about $30. Made both sides with some left over. I'm not sure on a B, but on a WD45 there are some places where gasket thickness is critical because it set gear mesh. So just watch out for that.
|
Posted By: CTuckerNWIL
Date Posted: 08 Oct 2019 at 9:00am
It totally depends on which gasket you need. Material and thickness is dependent on the use of the gasket. You can't make a thick cork gasket for an oil pump, and a thin gasket won't work well on the oil filter housing. I wouldn't even think about trying to make a head gasket, or one for the rocker cover. ------------- http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |
miketothesteve wrote:Posted By: miketothesteve
Date Posted: 08 Oct 2019 at 10:40am
| I likely need to replace the gasket around the oil pan. And the gaskets for the carb. What would you recommend? |
Posted By: HoughMade
Date Posted: 08 Oct 2019 at 12:01pm
|
If I can buy it, I buy it. I hade some for the thermostat housing because the shapes are simple and I had the gasket paper. I would not take on anything much larger or complex than those, myself. ------------- 1951 B |
Posted By: AaronSEIA
Date Posted: 08 Oct 2019 at 12:13pm
|
Go to http://www.djstractorparts.com" rel="nofollow - www.djstractorparts.com and buy the gaskets you need. Great to work with. AaronSEIA |