Print Page | Close Window

Three Point Hitch Conversion D17 III

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=164643
Printed Date: 27 Oct 2025 at 5:58pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: Three Point Hitch Conversion D17 III
Posted By: jeickman01
Subject: Three Point Hitch Conversion D17 III
Date Posted: 27 Sep 2019 at 5:42pm
The Cross 3 point hitch conversion won't work on my D17 Series 3 Serial Number 67086 because the Allis hitch bracket is too wide for the Cross anti-sway bracket that is supposed to straddle and bolt onto it.  Cross Mfg says that their kit should fit all WDs and D17 Series 1,2 and 3 but according to the parts book it looks like Allis widened this bracket at SN 24001 & up.  The Allis bracket is about the same overall width as the Cross anti-sway bracket so there is no way that I'm confused as to how to install it - it won't fit.  I'll stand corrected if someone can post a picture.  But until then, before I start cutting and welding, has anyone else run into this and have a recommended fix? 



Replies:
Posted By: DrAllis
Date Posted: 27 Sep 2019 at 7:20pm
Sounds like a series 4 hitch.


Posted By: AaronSEIA
Date Posted: 28 Sep 2019 at 7:56am
I have a hitch from a series 4 on my series 2, but I don't have the sway bar braces on mine to say how well they fit.  The sway bar brace that OK Tractor sells looks to be built with 2 sets of pin holes for the wide vs narrow drawbar hangar.
AaronSEIA



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net