one tough bolt
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=16298
Printed Date: 22 May 2025 at 6:02am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: one tough bolt
Posted By: Danny NM
Subject: one tough bolt
Date Posted: 07 Aug 2010 at 8:05pm
Hello everyone been trying to break free a support bolt on the radiator and guard assembly of a HD6. It has a flared head and is about 1.5 inche dia. NFT. The nut is square about 2 inches deep with a step for a retaining bracket. not having much luck. Was wondering if anyone might have a spare bolt & nut that they might part with? Thanks Danny
|
Replies:
Posted By: DMiller
Date Posted: 08 Aug 2010 at 12:43pm
| Are you sure it is a bolt and not a pin? Some pins are only equipped with a drive type for alignment purposes as they are splined or keyed to prevent installed rotation. Could it be possible to remove the nut and drive it out? |
Posted By: HD6GTOM
Date Posted: 08 Aug 2010 at 1:29pm
| It is a bolt, I will look and see if I can find 1 laying around |
Posted By: gemdozer
Date Posted: 08 Aug 2010 at 3:23pm
| I should have some bolts 086835 and some time they are not easy to remove and I have to check tomorrow morning for make sure. |
Posted By: Danny NM
Date Posted: 08 Aug 2010 at 5:14pm
Thanks you guys. a little good news. worked on it today still would not give up it's grip. if you find one please email me or call 505 425 6265 Danny
|
Posted By: gemdozer
Date Posted: 08 Aug 2010 at 6:45pm
|
Did you remove the smaller bolt each side off the guard and
try too pull the top guard in front side sometime it loosen
the big bolts from the guard and frame
|
Posted By: gemdozer
Date Posted: 09 Aug 2010 at 6:32pm
|
I check today but no chance to get my hand on the guard bolts maybe
they ben sold and I will recheck tomorrow again
|
Posted By: Danny NM
Date Posted: 21 Aug 2010 at 8:18pm
Hello everyone The bolt and nut finally parted ways. A welder,pipewrench,bottlejack,slug,sledgehammer,torch and alot of dreaming i was on some beach somewhere it gave up it's grip. So now maybe like Dadsdozerhd5b said it will run again. thanks for the help Danny
|