Farm Equipment - WD WIRING

Print Page | Close Window

WD WIRING

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=162565
Printed Date: 26 Aug 2025 at 2:37am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: WD WIRING

Posted By: davegoodell
Subject: WD WIRING
Date Posted: 07 Jul 2019 at 2:05pm

i NEED HELP WIRING A WD. iT WORKED PREVIOUSLY BUT HAS A SHORT SOMEWHERE.

i HAVE A 3 POLE LITE SWITCH AND A 2 POLE CUT OUT REGULATOR IN THE LITTLE DASH BOARD. hELP?

Replies:

Posted By: AC720Man
Date Posted: 07 Jul 2019 at 4:57pm

What symptoms are you having?Has a short somewhere? Did it blow the fuse? Wiring in a WD is very simple. Wiring issues were generally at the lights. They tee just under the gas tank where the light holding rods attach. I had to replace the wiring through each tube. Buy a new harness if the insulation is falling off. Cloth goes bad over time and causes shorts or grounds out.

-------------
1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD

Posted By: davegoodell
Date Posted: 07 Jul 2019 at 6:00pm

The wires heat up and the lites don't work and the ammetyer gauge doesn't work. The gauge is new also.