Farm Equipment - 200 Hydraulic Question

Print Page | Close Window

200 Hydraulic Question

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=161994
Printed Date: 22 Aug 2025 at 4:41am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 200 Hydraulic Question

Posted By: Unit3
Subject: 200 Hydraulic Question
Date Posted: 17 Jun 2019 at 8:07pm

1st open or closed center hydraulic and is that the same as the 7000 and 8000 series?

2nd I can get oil out of the 3 point by tying into a lift cylinder, but where would it get returned.

I am thinking about using it to pull a small sprayer around the fence lines. I would like to use the remotes to lift and lower the booms and swing them in and out. I want to run a spray pump with the hydraulics from the tractor.

-------------
2-8070FWA PS/8050PS/7080/7045PS/200/D15-II/2-WD45/WD/3-WC/UC/C

Replies:

Posted By: DrAllis
Date Posted: 18 Jun 2019 at 7:22am

OPEN CENTER and not like anything other than a 7000, not 7010 & up. You could use the 3-point lever (and return to sump) to run your sprayer pump, yes. BUT, when the pump is running you will not be able to lift either boom. You'll have to shut off the pump, position your booms where you want them and then turn the pump back on.

Posted By: Unit3
Date Posted: 18 Jun 2019 at 8:11am

I was hoping you might see this, DrAllis. Now where might one find a sump return port? Is it in the rear end or in the transmission? I see what looks like a plug in the rear end casting just to the left of the PTO and lower.

-------------
2-8070FWA PS/8050PS/7080/7045PS/200/D15-II/2-WD45/WD/3-WC/UC/C

Posted By: DrAllis
Date Posted: 18 Jun 2019 at 8:13am

NO !! You'll have to return it to the hydraulic fill/dipstick hole or the drain plug underneath the torque tube.