Farm Equipment - 7060 hydraulic filter light

Print Page | Close Window

7060 hydraulic filter light

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=159832
Printed Date: 10 Aug 2025 at 1:42pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 7060 hydraulic filter light

Posted By: timmiso
Subject: 7060 hydraulic filter light
Date Posted: 09 Apr 2019 at 9:36pm

Ok back at this thing. Basically a junkyard tractor that I’ve got most of the stuff fixed - just ac and this filter light to figure out.

New filters installed correctly (I believe) screen in on left side, spring in on right side. Cannot get filter and temp light off. (I think they’re together to check when starting). Book says it’s just a ground plate that should lose ground when the oil pushes the plunger off the seat therefore shutting the light off. What am I missing? I ran new wire from idiot light down to sender - still nothing. Wondering if the spring was changed at one time? Am I understanding it correctly that the incoming line is the one with the sender on it, and it goes thru the filter to return? Can’t wait for the rain to get out of here and to try it out doing some pulling.

Replies:

Posted By: exSW
Date Posted: 10 Apr 2019 at 11:25am

Go to the filter housing. Pull the lead off the sending unit. If the light stays on the lead is shorting out.

Posted By: timmiso
Date Posted: 10 Apr 2019 at 12:15pm

Yeah I did that - it was so I ran a new wire from the dash down - so now it does shut off if it’s disconnected

Posted By: MACK
Date Posted: 10 Apr 2019 at 8:25pm

Sounds like green board in dash is bad. MACK