185 Block Heater
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=155007
Printed Date: 18 Jul 2025 at 11:49am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 185 Block Heater
Posted By: Gary Burnett
Subject: 185 Block Heater
Date Posted: 24 Oct 2018 at 5:38am
|
Want to put a block heater on my 185 where does it go on the engine? |
Replies:
Posted By: automaticdave
Date Posted: 24 Oct 2018 at 6:10am
| Mine is @ the right rear above the starter |
Posted By: Gary(VA)
Date Posted: 24 Oct 2018 at 6:13am
|
Gary, If you send a email or cell number I can send a photo if you need one later this afternoon. |
Posted By: Gary Burnett
Date Posted: 24 Oct 2018 at 11:44am
Thanks email is gburnett570@earthlink.net
|
Gary(VA) wrote:Posted By: Hurst
Date Posted: 24 Oct 2018 at 12:37pm
|
Here's an image of where the block heaters usually are. I am not sure all blocks have the same freeze plug and bolt holes in the water jacket. My 7000's 301 is in the rear-most freeze plug/flange. This one is in the center. http://goo.gl/images/q1ctGw" rel="nofollow - http://goo.gl/images/q1ctGw Hurst ------------- 1979 Allis Chalmers 7000 5800 Hours |
Posted By: Gary(VA)
Date Posted: 24 Oct 2018 at 3:52pm
| Hurst photo is where mine in also. |
Posted By: Gary Burnett
Date Posted: 25 Oct 2018 at 7:46am
|
So take out the freeze plug and put in the heater? I found a new AGCO block heater on ebay and ordered it so I guess I'll see when it gets here. |
Posted By: Hurst
Date Posted: 25 Oct 2018 at 7:49am
|
Make sure you have the tapped holes if you are using the one that has the bolt-on flange. If it doesn't have 2 threaded holes, you can use one that will fit into the freeze plug and tightens using a screw through the center and a wing on the back to pull it tight. Hurst ------------- 1979 Allis Chalmers 7000 5800 Hours |