Muffler Install
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=149324
Printed Date: 23 Jun 2025 at 6:21am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Muffler Install
Posted By: cjallis
Subject: Muffler Install
Date Posted: 09 Apr 2018 at 6:39pm
|
Can anyone tell me what goes through the manifold and muffler to hold it in place from moving? There is a hole in the top of the manifold where the muffler attaches but it does not go all the way through manifold. Thanks, Carl
|
Replies:
Posted By: Larry in NC
Date Posted: 09 Apr 2018 at 7:01pm
| You did not say what tractor you are putting the muffler on, but the hole on the manifold is normally there to bolt through the flange on the muffler if the hole does not go all the way through the manifold. |
Posted By: cjallis
Date Posted: 09 Apr 2018 at 8:34pm
| It's on a C! Ok yes I thought so. |
Posted By: DSeries4
Date Posted: 10 Apr 2018 at 7:33pm
|
There are supposed to be 2 holes on the side of the manifold. The one
you can't see is probably broken off and rusted. It will need to get
drilled out and the hole re-tapped. Best to run the tap through the
other hole too. For bolts, use brass bolts only. The one that does
not go through the manifold will need to be cut shorter. This is on my WD45 ...  ------------- '49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080 |
Posted By: Lonn
Date Posted: 11 Apr 2018 at 6:18am
|
I believe a C would have only one bolt vs two on a WD45. ------------- -- --- .... .- -- -- .- -.. / .-- .- ... / .- / -- ..- .-. -.. . .-. .. -. --. / -.-. .... .. .-.. -.. / .-. .- .--. .. ... - Wink I am a Russian Bot |