D15 II not running right
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=146175
Printed Date: 01 Jun 2025 at 6:46am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: D15 II not running right
Posted By: Mikez
Subject: D15 II not running right
Date Posted: 05 Jan 2018 at 12:57pm
|
Hi. Pops was plowing snow, says that it ether full throttle or idling no in between. Think is governor or carburetor. Thanks
|
Replies:
Posted By: Tracy Martin TN
Date Posted: 05 Jan 2018 at 2:03pm
If all has been working OK before. Weather might be the culprit, ice or blockage of some kind around linkage. HTH Tracy
-------------
No greater gift than healthy grandkids!
|
Posted By: jaybmiller
Date Posted: 05 Jan 2018 at 2:33pm
I had to install 'side shields' on my D-14 last week. It channels the rad/engine heat to keep engine parts ,like carb, warm...
Side shields were made from old 'election' signs, plastic, corrugated, 1 nut and bolt holds them on !
Troy's been fine ever since !
Jay
-------------
3 D-14s,A-C forklift, B-112
Kubota BX23S lil' TOOT( The Other Orange Tractor)
Never burn your bridges, unless you can walk on water
|
Posted By: MACK
Date Posted: 05 Jan 2018 at 9:45pm
|
Governor may have come apart. MACK
|
Posted By: Mikez
Date Posted: 06 Jan 2018 at 7:59pm
|
He had it in the garage so is was warm. Guess thinking back it has been acting up for some time
|
Posted By: WD45
Date Posted: 08 Jan 2018 at 8:45am
Check the gas flow at carb. Drain gas tank and put fresh number 1 gas in tank.
-------------
Fred Dunlop, G,B,CA, WC,WF, 3 WD45`s,gas, diesel and LP,U,D10 series III, D12,D14,D15 SERIES II,D17 Series IV in Gas and Diesel ,D19 GAS and D21,170 185,210 ,220 an I-600 8070 fwd, 716H and 1920H
|
Posted By: dt1050
Date Posted: 09 Jan 2018 at 7:28am
make sure linkage isn't binding up any were. the person who had my wd45 before me put a nail in the govoner linkage to the carb, it was to long and was hitting the block when the govoner would try to kick in. dt
-------------
Just cause it's orange don't make it a tractor, there's only one..Allis Chalmers
|
Posted By: Mikez
Date Posted: 09 Jan 2018 at 7:46am
|
Ok guys thanks.ill have dad check your those things
|
Posted By: LeonR2013
Date Posted: 09 Jan 2018 at 9:42am
|
Is it over reving when you open it up with no load? If it does, more than likely You have broken weights in the gov. DO NOT start it if it does. Get all the pieces out first. Also check the gov. shaft for slack in the bushing. They'll break brand new ones with a worn shaft and bushings.
|
|