F2 gleaner
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=143980
Printed Date: 10 May 2025 at 8:04am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: F2 gleaner
Posted By: Keith49
Subject: F2 gleaner
Date Posted: 30 Oct 2017 at 10:27pm
|
I have an F2 gleaner with a 430 corn head I use for my few ackers of corn for my cattle.While combining corn a loud clicking noise started coming out of the console and the amp gauge pegs from full charge to full discharge. It shuts the feul off with each click. The little 4 cyl diesel usually runs great. I hate electrical issues. Any ideas?
|
Replies:
Posted By: tbran
Date Posted: 31 Oct 2017 at 12:11am
run a large like #8 jumper wire from one side of the main solenoid terminal to the other and see if it stops. Issue is key switch, loose wire from key switch to solenoid, the solenoid or the ground to the solenoid - one of the small wires.. the other small terminal on the solenoid is 12v from key switch.
-------------
When told "it's not the money,it's the principle", remember, it's always the money..
|
Posted By: DougS
Date Posted: 31 Oct 2017 at 5:58am
|
Yeah. I'd also say loose connection somewhere. Check all grounds too.
|
Posted By: AC200Puller
Date Posted: 31 Oct 2017 at 6:22am
Also check it over good for a hot wire that is grounding out if the amp gauge went to full discharge!
|
Posted By: MACK
Date Posted: 31 Oct 2017 at 9:15am
I would say a loose connection some where from starter to key switch or key to solenoid on console door.
The solenoid don't shut pump off, the key switch shuts both off. It will start and run without the solenoid.
Also check ground on solenoid. MACK
|
Posted By: Keith49
Date Posted: 31 Oct 2017 at 9:37am
|
Thanks guys, I'll give these things a try, thanks much
|
|