Print Page | Close Window

D17 transmission questions

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=141428
Printed Date: 01 Jan 2026 at 12:03am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: D17 transmission questions
Posted By: gerkendave
Subject: D17 transmission questions
Date Posted: 13 Aug 2017 at 10:33pm
Hey everyone. Still searching for a good transmission to go into my series 4. Just curious if a tendon from an earlier series is the same or not. Thanks



Replies:
Posted By: DrAllis
Date Posted: 14 Aug 2017 at 7:10am
If you are looking for a complete rear end/transmission assembly for a D-17 S4, it has to be from another S4 or a One-Seventy. What is wrong with yours??


Posted By: gerkendave
Date Posted: 14 Aug 2017 at 8:26am
Thanks Dr! The one on mine is jumping second and third gears. It's bad enough on third that even after moving the shift detent you can't even hold it in with your hand under a load. Was hoping to find a 170 or factory three point 17 with a good transmission for less than the gears and bearings would add up to to fix mine.


Posted By: Roger (NE)
Date Posted: 14 Aug 2017 at 8:41am
Series IV is the same whether factory 3 point or factory snap coupler...they interchange and either will bolt right up and be correct.



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net