Assembly question
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=138022
Printed Date: 08 Nov 2025 at 11:48pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Assembly question
Posted By: NDBirdman
Subject: Assembly question
Date Posted: 02 May 2017 at 2:55pm
|
I'm putting my 226 togather, slowly/finally. I should have taken pictures but I'm a day late and a dollar short, so the question. On the bottom side, oil pump, where the supply line goes from the pump to the block. There are 2 holes next to the line (on the block). I don't remember taking anything out of those 2 holes but they are threaded which makes me go hmmmm. The look like the only time oil would pass is when the plunger is depressed enough to slide back enough to open up. Does anything go there? I have 3 manuals and non of them show/tell what they are. I have seen one pic online (here) that shows plugs in there but looking through all the parts I removed, I don't have any that fits there. Thanks ------------- 1955 WD45 S#205467, 190XT #6652 DXT |
Replies:
Posted By: SteveM C/IL
Date Posted: 02 May 2017 at 10:28pm
| On bypass oil system those are drain for relief valve. Can't say on full flow as I haven't seen inside one.I converted my WD45 bypass to full flow and those holes are now plugged. |
Posted By: NDBirdman
Date Posted: 03 May 2017 at 8:37am
Thank-you. I thought those remained open but figured better safe then not to ask. Can't wait to hear this old gal run. ------------- 1955 WD45 S#205467, 190XT #6652 DXT |
SteveM C/IL wrote:Posted By: Allis dave
Date Posted: 03 May 2017 at 10:34am
| Steve is correct |