Print Page | Close Window

CA Governor Shaft Loose

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=136417
Printed Date: 08 Nov 2025 at 7:54am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: CA Governor Shaft Loose
Posted By: CA52
Subject: CA Governor Shaft Loose
Date Posted: 20 Mar 2017 at 12:10pm
I was inspecting the oil lines going to the governor on my CA, and noticed the shaft coming out the top where the oil ling goes in is loose. It wiggles some and I can pull it straight up a 1/4" or so and see splines. What am I looking at to fix this?

Thanks for any help



Replies:
Posted By: Dick L
Date Posted: 20 Mar 2017 at 3:41pm
Red locktite is one way. You want to clean the oil off both the hole and pin first. If the hole is really sloppy JB Weld will work also.


Posted By: rpropst
Date Posted: 20 Mar 2017 at 4:07pm
x2 on JB weld.

-------------
1950 snap coupler B 1948 WD 1951Ca 1952B 1952adjustable axel B


Posted By: ac fleet
Date Posted: 20 Mar 2017 at 8:18pm
I have 3 of them on C tractors that are the same way! thanks; ac fleet


Posted By: DrAllis
Date Posted: 20 Mar 2017 at 9:30pm
Pull it out and use a center punch all the way around it to make it look like a golf ball. Clean and use RED Loctite and allow to cure.


Posted By: CA52
Date Posted: 21 Mar 2017 at 9:17am
Sounds like a plan! Thanks for the help all!



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net