190 no hydraulics
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=128034
Printed Date: 08 Sep 2025 at 8:42am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 190 no hydraulics
Posted By: Mrgoodwrench
Subject: 190 no hydraulics
Date Posted: 30 Aug 2016 at 9:26am
Got to play with our "new" series I xt this weekend. Originally we bought it for parts but now think we are gonna save it and make a loader out of it. It gets water in the engine oil but I've fixed 3 of those so far so not unfamiliar with that but it has no hydraulics at all. No lift drive or steering. Oil is full pump is quiet. Is there anything besides a pump that could cause this? Also we did get coolant running out of the bell housing or above when we winched it onto the trailer...is there a soft plug in the rear of block? I've never had a 301 completely out of frame...this one will be coming out as the rear seal is out of it.
-------------
There are 3 ways to do job GOOD, FAST, CHEAP. YOU MAY CHOOSE 2. If its FAST & CHEAP it won't be GOOD, if it's GOOD & CHEAP it won't be FAST, and if its GOOD & FAST it won't be CHEAP!!!!
|
Replies:
Posted By: Mrgoodwrench
Date Posted: 30 Aug 2016 at 8:13pm
Has anyone heard of a broken pump shaft? Haven't got it apart yet bet tractor
Lost all bus power at once...seems kinda odd
-------------
There are 3 ways to do job GOOD, FAST, CHEAP. YOU MAY CHOOSE 2. If its FAST & CHEAP it won't be GOOD, if it's GOOD & CHEAP it won't be FAST, and if its GOOD & FAST it won't be CHEAP!!!!
|
Posted By: MACK
Date Posted: 30 Aug 2016 at 10:18pm
|
Pump has lost prime or striped splines from drive gear. MACK
|
Posted By: Mrgoodwrench
Date Posted: 30 Aug 2016 at 10:44pm
It stopped on the previous owner while running a brush hog for a few hours so I doubt it lost prime so I guess I'll check the splines. I'll probably just wait till I pull the engine
-------------
There are 3 ways to do job GOOD, FAST, CHEAP. YOU MAY CHOOSE 2. If its FAST & CHEAP it won't be GOOD, if it's GOOD & CHEAP it won't be FAST, and if its GOOD & FAST it won't be CHEAP!!!!
|
Posted By: Mrgoodwrench
Date Posted: 18 Sep 2016 at 9:09am
Looking a littler more I found out the hyd level was near empty when it got hauled but my FIL had filler it before I got there. So I'd better make sure the pump has not lost prime....so how do I do that
-------------
There are 3 ways to do job GOOD, FAST, CHEAP. YOU MAY CHOOSE 2. If its FAST & CHEAP it won't be GOOD, if it's GOOD & CHEAP it won't be FAST, and if its GOOD & FAST it won't be CHEAP!!!!
|
|