Oxnard blade question
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=127107
Printed Date: 13 Sep 2025 at 1:51am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Oxnard blade question
Posted By: Hubnut
Subject: Oxnard blade question
Date Posted: 11 Aug 2016 at 6:21pm
|
I got a manual for my Oxnard scraper blade. It indicates that a cross member should be added across the upper lift arms. I've never seen this before. Is this necessary? Looks like a piece of angle stock connecting the lift arms. ------------- 1940 B "Lucy" 1941 B w/ Woods L59 "Flavia" 1942 B w/ finish mower "Dick" 1941 C w/ 3-point "Maggie" 1947 C SFW w/ L306 "Trixie" 1972 314H |
Replies:
Posted By: DiyDave
Date Posted: 11 Aug 2016 at 6:28pm
If its what i think it is, its an anti-sway bar, to keep the blade from pulling left or right. I'd just fab up 1 that looks close...
|
Posted By: Gary
Date Posted: 11 Aug 2016 at 6:36pm
|
On the Allis Snap Coupler Blade, the anti-sway is accomplished with 2 flat bars that are attached at the bottom of each lift, and are pinned at their other end to the centre of the flat cross bar between the Lift Arm Latches. Gary
|