Farm Equipment - Turn sighal switch 7020

Print Page | Close Window

Turn sighal switch 7020

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=111732
Printed Date: 14 Sep 2025 at 12:38am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Turn sighal switch 7020

Posted By: leader58
Subject: Turn sighal switch 7020
Date Posted: 09 Sep 2015 at 3:34pm

Can anyone tell me which wires go on which terminals? Turn signals work but 4 ways do not. Has a new nos switch. Thanks

Replies:

Posted By: SHAMELESS
Date Posted: 09 Sep 2015 at 3:38pm

it should be the regular light switch that's bad, not the turn signal switch. had that happen on my 7010 once!

Posted By: SHAMELESS
Date Posted: 09 Sep 2015 at 5:36pm

oh...and if you get a new one from AGCO, it'll come with an extra wire and some kinda silly instructions. I didn't use the extra wire when I replaced the switch and it has worked perfectly for past 10 years or so!

Posted By: Lonn
Date Posted: 10 Sep 2015 at 6:49am

Is that switch different from a 7050 Shameless? I put a new one in a couple years ago but don't remember an extra wire.......but I don't remember a lot of things.

Say, did you find that coulter blade?

-------------
-- --- .... .- -- -- .- -.. / .-- .- ... / .- / -- ..- .-. -.. . .-. .. -. --. / -.-. .... .. .-.. -.. / .-. .- .--. .. ... -
Wink
I am a Russian Bot

Posted By: SHAMELESS
Date Posted: 10 Sep 2015 at 9:36am

Lonn...my light switch is on the right side of the steering wheel, the turn signal switch is on the left side of my steering wheel....dunno if the older maroon belly tractors are the same? and no...haven't been able to walk out to check for the blade...and what another said about using a disk blade sounds like a good idea too! just hafta blow a few holes in one and bolt it up tight! sounds like a cheap fix! even if you hafta use a new blade.

Posted By: Lonn
Date Posted: 10 Sep 2015 at 10:35am

I do have some old but good 19" blades from a Miller disk. You know that might be worth a try.

-------------
-- --- .... .- -- -- .- -.. / .-- .- ... / .- / -- ..- .-. -.. . .-. .. -. --. / -.-. .... .. .-.. -.. / .-. .- .--. .. ... -
Wink
I am a Russian Bot