Farm Equipment - O/C New Holland 575

Print Page | Close Window

O/C New Holland 575

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=109377
Printed Date: 15 Sep 2025 at 3:45pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: O/C New Holland 575

Posted By: Mike Plotner
Subject: O/C New Holland 575
Date Posted: 23 Jul 2015 at 9:32pm

baler wont drop the knot on the left side (when facing back of tractor). replaced the bill hook and adjusted the wiper arm and still nothing.

had the same problem on a 336 deere but I cant remember exactly what it was that fixed it but I recall a wire being broker right above the bale chamber

-------------
2001 Gleaner R42, 1978 7060, 1977 7000, 1966 190 XT, 1966 D-17 Series IV and 1952 WD and more keep my farm running!

Replies:

Posted By: kev/ont
Date Posted: 24 Jul 2015 at 4:10pm

Is it just the tail of the knot left in the slot? If it is loosen the tensionon the bill hook tongue 1flat at a time until the tail drops out.

Posted By: michaelwis
Date Posted: 24 Jul 2015 at 4:52pm

are the tucker arms free

-------------
WD WD45 DIESEL D 14 D-15 SERIES 2 190XT TERRA TIGER ac allcrop 60 GLEANER F 6060 7040.and attachments for all Proud to be an active farmer

Posted By: Dan73
Date Posted: 25 Jul 2015 at 9:58pm

My NH 565 had all kinds of knotting issues a while back. The hardest problem with mine to find was the hay dog springs on the bottom side of the hay chamber being worn out. The last owner replaced the top dog springs but not the bottom. With the hay chamber empty check to see that the hay dogs are held back hard against the frame. If they don't hold the first section of the next bale back you can get all kinds of weird knotting problems that come and go based on how thick the hay is.
Also check that the shaft for the knife is actually tight mine was flopping around loose I ended up having them sleeved to tighten them up. Mine where loose enough that I could adjust the knife to the bill hook but when I lowered the knotters to the working height the adjustment was inconsistent and the knot would be stuck on the bill hook.