L2 harmonic balancer
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=107965
Printed Date: 10 Sep 2025 at 9:07pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: L2 harmonic balancer
Posted By: 2wise4agm
Subject: L2 harmonic balancer
Date Posted: 23 Jun 2015 at 6:41am
| The harmonic balancer on our L2 (426) is going bad. (The outside part has slipped on the inside piece.) I thought I remembered seeing some place that would rebuild them but I can't seem to find it. Anyone know? |
Replies:
Posted By: Adam Stratton
Date Posted: 23 Jun 2015 at 7:19am
|
http://hbrepair.com/harmonicbalancer_018.htm" rel="nofollow - http://hbrepair.com/harmonicbalancer_018.htm
This is where I sent mine off an L2. It was right around $200 to do the pulley I sent. I have no complaints and would use him again. Took a little over a week including shipping. The combine where the balancer went bad had been running hot, and I had hoped that maybe the pulley had been slipping before I knew it, and it would run cooler now, not the case, so I need to keep looking there....
|
Posted By: 2wise4agm
Date Posted: 25 Jun 2015 at 8:13pm
| Thanks for the reply. Hopefully we'll finish up the fescue and wheat this week and I'll get it off and send it to them. |
Posted By: Mike Plotner
Date Posted: 25 Jun 2015 at 8:27pm
|
better replace it now, the one on my L2 kicked off last fall while shelling corn. when that goes the combine just stops. I didn't have time to send it off to get it fixed right and there is none to be found in any salvage yards within a few hundred miles. I just used a harmonic balancer off a 7045 and it works fine ------------- 2001 Gleaner R42, 1978 7060, 1977 7000, 1966 190 XT, 1966 D-17 Series IV and 1952 WD and more keep my farm running! |
Posted By: ranger42
Date Posted: 26 Jun 2015 at 8:30am
What were the symptoms of it slipping? Just curious because I have always been paranoid about the one on the 210 slipping. |
2wise4agm wrote:Posted By: 2wise4agm
Date Posted: 26 Jun 2015 at 8:34am
| I had the injection pump rebuilt and the timing marks weren't even close to being lined up when I went to remove the pump. |
Posted By: SteveM C/IL
Date Posted: 26 Jun 2015 at 9:50am
Make sure you check your guage /sender against a know accurate one. |