Seal kit needed, I600 steering cylinder.
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=104355
Printed Date: 20 Jul 2025 at 1:07am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Seal kit needed, I600 steering cylinder.
Posted By: vooodooo
Subject: Seal kit needed, I600 steering cylinder.
Date Posted: 05 Apr 2015 at 6:48pm
My steering ram leaks badly.
I am looking for a seal kit, and some advice on how do it.
On a positive note, the gasser engine was running like poop. Bad spark intermittent. Just for piece of mind I did a compression test. 135 on all four.
Did a pertronic swap for the points, changed plugs, coil, wires, cap and she runs like a champ.
It runs so well I haven't even bothered to time it.
|
Replies:
Posted By: Eric B
Date Posted: 07 Apr 2015 at 12:48pm
If you have a good local hydraulic shop they should be able to get the right seals for your power steering ram. Sounds like you got it running good. I have found every time I put in a Pertronix kit I have to advance the timing to get it right.
-------------
Currently- WD,WC,3WF's,2 D14's B. Previously- I 600,TL745,200,FL9,FR12,H3,816 LBH. Earth has no sorrow that Heaven cannot heal!
|
Posted By: DSeries4
Date Posted: 08 Apr 2015 at 6:50pm
Ditto to Eric. Take the cylinder to a good hydraulic shop. They will take care of it.
-------------
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080
|
|