Allis two bottom plow
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=103580
Printed Date: 10 Sep 2025 at 12:26am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Allis two bottom plow
Posted By: dustinmars
Subject: Allis two bottom plow
Date Posted: 22 Mar 2015 at 6:42am
 Does anyone know if this is an Allis plow or not? |
Replies:
Posted By: DiyDave
Date Posted: 22 Mar 2015 at 7:07am
| No beaming screw, might just be a well done cut down of SC plow... |
Posted By: PaulB
Date Posted: 22 Mar 2015 at 10:42am
| I'll second Dave's opinion. It's a 60 series that has been made into a 3pt model. AC would not have welded the mast to the frame. |
Posted By: Gerald J.
Date Posted: 22 Mar 2015 at 11:35am
|
If you study the plow parts manual referenced in AC Plows Parts 101 above you will see that the AC frame is the same for all hitches, that the three point, SC, and pull behind are bolt ons. It is a 62 and the tower would have slid on the three point lower lift bar. The upper link of three point provides the tilt adjustment provided by the beaming screw in the SC. Gerald J. |
Posted By: dustinmars
Date Posted: 22 Mar 2015 at 5:32pm
|
Thanks guys I don't mind that it was cut down and made into three Point but I didn't want to buy it if it wasn't a part of an allis plow. This will be great on my D15. |
Posted By: Gerald J.
Date Posted: 22 Mar 2015 at 6:29pm
|
It hasn't been cut. Just the three point hitch has been welded on where an AC three point hitch would have been bolted on. Gerald J. |