Farm Equipment - d-15 govenor help

Print Page | Close Window

d-15 govenor help

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=101416
Printed Date: 09 Sep 2025 at 11:40am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: d-15 govenor help

Posted By: marion
Subject: d-15 govenor help
Date Posted: 03 Feb 2015 at 6:57pm

governor all sloppy on series 2 gas d-15

I ordered all my stuff and am wondering how to get the bronze bushing out of the front governor cover. I figure I can drive it back in with block of wood along with the busing on tach end of things I can drive it out. but not this one

thanks

Replies:

Posted By: tbran
Date Posted: 03 Feb 2015 at 10:04pm

Many years ago I saw an old tech tap the bushing with thread tap - screw in a long bolt, then submerge the cap /cover into hot oil - and pull the bushing out. Don't know what model tractor it was but principle the same....

Posted By: Tracy Martin TN
Date Posted: 03 Feb 2015 at 10:14pm

Thread the bushing like tbran mentioned. You can use slide hammer, or piece of all thread with a section of pipe or large socket.If you use the pipe or socket,slide it over the all thread, put a washer over end of all thread, start a nut on all thread and tighten it till it pulls the bushing from cover. HTH Tracy

-------------
No greater gift than healthy grandkids!