This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Other Topics > Pulling Forum
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


190 transmission rear end oil level

 Post Reply Post Reply
Author
Message
brad7066 View Drop Down
Bronze Level
Bronze Level


Joined: 13 Mar 2022
Location: wisconsin
Points: 37
Post Options Post Options   Thanks (0) Thanks(0)   Quote brad7066 Quote  Post ReplyReply Direct Link To This Post Topic: 190 transmission rear end oil level
    Posted: 13 Mar 2022 at 7:42pm
how much over the full line should i be running my 190. it has a coupler in it with no hydraulics 
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 19360
Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 14 Mar 2022 at 9:17am
For pulling?? the higher the better, to flood the differential gears. Use light weight (HyGuard/HyTran/821XL/Permatran) oil, not 80/90 wt.  Oil level can be as high as half-way submerging the top shaft in the transmission and then that will have the differential half submerged too.  Needling the differential is a good thing.
Back to Top
tbran View Drop Down
Orange Level
Orange Level


Joined: 14 Sep 2009
Location: Paris Tn
Points: 3213
Post Options Post Options   Thanks (0) Thanks(0)   Quote tbran Quote  Post ReplyReply Direct Link To This Post Posted: 14 Mar 2022 at 1:41pm
as to the front end - if you have no PD clutch - many take out the torque housing gears and put in sealed bearings so one needs no oil - IF you still have the torque housing gears we put oil jugs in bottom of center housing and foam to cut down on amount of oil needed -but you have to keep those cone/cup needle brgs in the front housing wet... about normal on RH dipstick...
  
When told "it's not the money,it's the principle", remember, it's always the money..
Back to Top
brad7066 View Drop Down
Bronze Level
Bronze Level


Joined: 13 Mar 2022
Location: wisconsin
Points: 37
Post Options Post Options   Thanks (0) Thanks(0)   Quote brad7066 Quote  Post ReplyReply Direct Link To This Post Posted: 14 Mar 2022 at 2:09pm
differential gears have been needled was told by them to run mystik synthetic. 
Back to Top
goomer View Drop Down
Bronze Level
Bronze Level


Joined: 18 Feb 2016
Location: wi
Points: 48
Post Options Post Options   Thanks (0) Thanks(0)   Quote goomer Quote  Post ReplyReply Direct Link To This Post Posted: 14 Mar 2022 at 10:16pm
I drilled and taped a drain plug on the circle plate on side of torque housing just about even with clutch main shaft. I keep filling until oil comes out. Takes a bit of time to get oil there.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.059 seconds.


Help Support the
Unofficial Allis Forum